Ironset Fremont ConcreteIronset Fremont Concrete(510) 574-8512Request an estimate

Concrete Contractor in Cherryland, CA - Driveways and Patios on a Solid Base

Ironset Fremont Concrete is a Fremont, CA concrete contractor that builds driveways, patios, walkways, steps and slabs in Cherryland. I come out for every estimate and stay on site for the pour, and our crew does the work.

Broad concrete steps rise to a gray front door, bordered by low stone walls and landscaped plants.
  • Licensed and fully insured.
  • Free estimates at your property.
  • We reply within 1 business day.

Cherryland houses and the concrete around them

Cherryland sits just north of Hayward, and the county's plans put it in the same Eden Area as San Lorenzo. It's mostly homes, so the calls we get here are mostly for flatwork, the driveways, patios and walks around a house. That means a driveway cracked and lifting at the street, a back patio that holds water, or a front walk broken into pieces.

Plenty of the houses are older, and so is the concrete. A lot of lots run long and narrow, so how we get the truck in and the old slab out shapes many of the jobs here.

Concrete work we do in Cherryland

  • Concrete driveway building

    When an older driveway has cracked, sunk at the street or tipped toward the garage, we tear it out, rebuild the base and pour a new one.

  • Concrete patio construction

    A backyard patio that holds water after rain usually wasn't sloped. We set the grade so water runs away from your house before we pour.

  • Stamped concrete services

    Stamped concrete gives a patio or walk the look of stone or brick in one pour, and it still needs the same packed base underneath.

  • Concrete sidewalk building

    We replace front walks and side paths that have heaved into trip hazards, and a broom finish, a brushed texture, keeps them grippy when wet.

  • Garage floor concrete

    An old garage slab that's cracked, stained or sunk at one corner can come out and go back in, poured thick enough to carry a car.

  • Decorative concrete

    Colored or scored finishes let a front entry or patio suit an older house, and we settle the look with you before the pour.

  • Concrete retaining walls

    Where soil pushes against a fence or slides toward a driveway, a concrete retaining wall holds it back, set on a footing sized for the load.

  • Concrete floor installation

    For a new shop, shed, studio or room addition, we pour an interior floor slab over a packed base with a vapor barrier under it.

  • Concrete pool decks

    Around a backyard pool, we pour decks that slope away from the water and the house, with a finish that stays grippy for bare feet.

  • Concrete steps construction

    Front steps that have settled or pulled away from the house get rebuilt with rebar, steel bars set inside the concrete, so they hold together.

  • Slab foundation building

    For a backyard unit, garage or addition on your lot, we build slab foundations on a dug-out, compacted base, because the slab carries everything above it.

  • Foundation installation

    When an addition or new structure needs a foundation, we set the forms and steel and pour it to the plans drawn for your lot.

  • Concrete parking lot building

    Small lots for shops, churches and apartment buildings get a thicker slab and joints laid out for the traffic they carry.

  • Concrete footings

    Fences, decks, patio covers and sheds need concrete footings, the buried pads that carry the weight, dug to the depth the job calls for.

  • Foundation raising

    When one side of a slab or room has dropped as the ground settled, we look at what's under it and lift it back toward level.

  • Concrete cutting

    We saw-cut old concrete for new doorways, plumbing trenches or a cleaner edge, and cut control joints, the grooves that tell a slab where to crack.

Get a free written estimate for your Cherryland job

Send the form and we'll reply within one business day to set a time. I'll come out, look at the job and put the price and the work in writing, with no obligation.

Email
hello@fremontcaconcrete.com
Based in
Fremont, CA 94538
Hours
Mon–Fri: 8 AM–11 PM, Sat–Sun: 6 AM–10 PM

Working in Cherryland means working with Alameda County

Cherryland has no city hall because it's an unincorporated community, so Alameda County is the local government and the county issues building permits here. Work that reaches into a county sidewalk or road, like the apron where a driveway meets the street, goes through the county's public works permits as well. When a job needs a permit, the county's review comes before we dig, so it sets the start date more than our calendar does. Before you hire anyone, check two things: a state contractor's license and the county business license. We're licensed and fully insured, and when a permit is needed we handle the paperwork and inspections with the county.

The price here moves mostly with what we find under the old slab and how much has to come out, then with the size and the finish you pick. The schedule turns on the permit, if there is one, and on the wait for the concrete to cure before you use it, and your estimate is where you get your own numbers. We're based in Fremont and take jobs in the cities around it, from here across the bay to North Fair Oaks, so if you're not sure we come to you, call (510) 574-8512 and ask.

Old slabs here usually fail from the ground up

A lot of the concrete around Cherryland houses has been there for decades, and much of it was poured on dirt that was raked flat instead of dug out and packed. That dirt keeps settling and roots keep pushing, so the slab cracks and sinks with it, and you end up with a lip at the garage or a walk you trip on. Patching the top doesn't fix that. We cut out the bad section or the whole slab, dig down to firm ground and build the subgrade, the packed layer the concrete sits on, before anything gets poured.

The other thing we see is water. A patio or driveway poured flat, or tipped toward the house, sends rain against your foundation, and it shows up as pooling, stains or a damp garage, so we set the slope before the pour.

How a concrete job in Cherryland goes, start to finish

From your first call to the day you walk on the new slab, here's how it goes and who you'll deal with.

  1. Call or send the form

    Tell us what's going on with your slab, and we set a time for me to come out and look. It helps if you're there so we can walk it together.

  2. I look, measure and price

    I measure, check what's under the old concrete where I can and ask what you need it to carry, then you get a written estimate that spells out the base, the steel and the joints, so you can see what you're paying for before you decide. Any permit gets sorted out before we dig.

  3. We prep, pour and clean

    Our crew digs out, packs the base, sets the forms and steel and pours with me on site, then cuts the control joints and leaves the slab to cure, the slow hardening that gives it its strength. We clean up before we leave, and you stay off it for a few days, longer before you drive on it.

Questions about concrete work in Cherryland

How do I get a building permit for concrete work in Cherryland?

Building permits for Cherryland go through the Alameda County Permit Portal, which handles the county's unincorporated areas. That's where applications and plans go in, where inspections get scheduled and where you can check a permit's status. Whether your driveway or patio needs one depends on the job, so we settle that with the county before we dig and handle the paperwork when it does.

What makes a new concrete driveway cost more in Cherryland?

Tearing out and hauling off the old slab, and rebuilding a bad base under it, usually add the most. After that it's the size, how thick the slab is, how much steel goes in, the finish and how easy it is to get a truck to the spot. If the budget's tight, take a plainer finish before you cut the base, because the base is what keeps the slab from cracking and sinking later.

What causes concrete driveways to crack and sink in Cherryland?

Usually it's the base, because dirt that was raked level instead of dug out and packed keeps settling and the slab goes with it. Joints cut late or skipped let cracks land wherever they want, and a pour in the midday heat can leave a weak, dusty top. We pack the subgrade, cut the joints on time and pour early, so any cracking tends to stay in the joints and the slab stays level.

Does a Fremont contractor need a county business license to work in Cherryland?

Yes, the county requires a business license for any business working in its unincorporated areas, even one based in another city or already licensed there. It's a yearly tax, and the license only shows the tax is paid, so it doesn't tell you a contractor knows the work. That's what the state license is for.

When does a concrete job in Cherryland need a state-licensed contractor?

Any time the job needs a building permit, uses hired workers, or runs $1,000 or more in labor and materials together. The state licensing board only lets someone skip the license when none of that applies and they don't advertise as licensed. A contractor also has to hold the license before bidding, so ask for it with the estimate.

Does the Hayward Fault affect concrete work in Cherryland?

It matters most for foundations and new structures. The Hayward Fault runs along the eastern edge of the Eden Area, the county planning area that takes in Cherryland, and the state maps zones where liquefaction, wet ground going soft in a strong quake, may occur. A property inside one of those zones may need that hazard studied during permitting, so for foundation work we look at your address before the plans are priced.

Fremont, CA

Get your Cherryland slab looked at

A slab that's just starting to crack or sink can sometimes be fixed in sections, and that gets harder the longer water and settling keep working on it.